Simrad AP24 Installationshandbuch PDF herunterladen (Seite 8)

Operation | 7

2 Installation

An autopilot system includes several units that need to

be mounted in different locations on the boat, and also

need to connect with at least three different systems on

the boat:

• EVC Autopilot Interface

• The boats electrical system (12V SimNet power)

• Other equipment on board (SimNet/NMEA interfacing)

In addition, the advanced capabilities of the system

require the installer to perform a series of settings and

tests to verify proper operation of the system, refer to

the check list below.

2.1 Installation checklist

1. Determine the system configuration you are

installing (Page 8)

2. Perform the hardware i

nstallation (Page 10)

3. Connect Si

mNet devices to SimNet (page 15)

4. Perform S

et-up (refer to Operator manual)

5. Test Autopilot Operation at Sea (refer to Sea Trial

instructions in the Operator manual)

2.2 Unpacking and handling

Care should be taken when unpacking and handling the

equipment. A visual inspection should be made to see

that the equipment has not been damaged during

shipment and that all components and parts are present

according to the packing list.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Keine Kommentare

Simrad AP24 Installationshandbuch Seite 8