Simrad GC80 Bedienerhandbuch PDF herunterladen (Seite 12)

INSTRUCTION MANUAL

20221487 / B 7

If the signal is invalid or missing after 1 second, this will be

indicated with flashing heading display.

When the defined input signal is lost, power must be switched

off and on again. If the cable not is connected via an external

switch, the cable must be disconnecting and reconnected again

to define a new input signal.

Adjusting display illumination

The display illumination on both displays may be adjusted by

using the dimmer buttons.

DIGIT

DIM

BAR

DIM

DIM BAR button is used for adjusting the illumination on the

Turn indicator.

DIM DIGIT button is used for adjusting the back lighting on the

Heading display.

When a dimmer buttons is pressed, the illumination will be

increased/decreased until the button is released.

Display modes for Turn indicator

DR76’s Turn indicator may be set to 3 different display modes,

defined as Mode 0, 1 and 2.

Mode 0:

Rate of turn indicator with fine resolution. For each 1/10°

the vessel’s bow turns, three bargraphs will move to left or

right on the indicator.

TURN INDICATOR

Mode 1:

As for Mode 0, but with the bargraphs indicating each 1°

turn.

Mode 2:

In this mode the Turn indicator acts as a set steering

display. When the vessel’s heading is identical to set

course, all LEDs are unlit. For each degree steered off-

course, one LED will be lit.

TURN INDICATOR

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Keine Kommentare

Simrad GC80 Bedienerhandbuch Seite 12