Simrad GC80 Bedienerhandbuch PDF herunterladen (Seite 18)

INSTRUCTION MANUAL

20221487 / B 13

3.5 Commissioning

Perform the following tests when commissioning the repeater:

7 Ensure that the mechanical installation and cable

connection has been completed according to the

description on previous pages

8 Connect the cable to the repeater. The repeater will

automatically sense which digital signal that is present

- The repeater will align itself to zero and then to the

transmitted gyro heading

9 Ensure that the lighting is set to a suitable level. Adjust if

necessary with the dimmer button

3.6 Fault finding

The AR68/AR77 are sealed units, and breakage of the security

seal will invalidate the warranty.

If trouble is encountered, make preliminary checks as described

below. If the problems remain unsolved, contact your nearest

Simrad dealer for assistance.

Symptom Probable fault Remedy

The repeater does not

operate.

No power or incorrect power

connection.

Check incoming power

supply.

The repeater aligns itself

to zero and does not

respond to heading

input.

The dial rotates +/- 35°.

The digital signal to the repeater is

either not present, or the sentence

being sent is incorrect or has wrong

polarity.

Switch the unit off and on

again.

Lighting not visible Damage to internal LED, or

damage to internal PCB.

Return to Simrad dealer for

service.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Keine Kommentare

Simrad GC80 Bedienerhandbuch Seite 18