Simrad ITI Bedienungsanleitung PDF herunterladen (Seite 9)

Instruction manual

857-164777 / A

1INTRODUCTION

Note This document is intended for software engeneers. It is t o be used

for writing codes in order to communicate with the ITI system.

With the rapid development of marine electronic devices, it has

become necessary to develop a standardised interface protocol for

exchanging data between devices regardless of the device

manufacturer. The NMEA 0183 standard protocol for interfacing

electronic marine deviceshasbeen implemented in theITIsystem.

The most common way of connecting elect ronic equipment is t o

use serial lines.

A more powerful way of integrating, is the Ethernet standard with

higher signalling capacity. The software required tocommunicate

over the Ethernet is includedin the ITI system, however a standard

ITI does not include the hardware required.

A dedicated interface/display board containing the Ethernet

hardware must be installed.

→ Please refer to the Simrad ITI Installation Manual, Appendix 1

page 3 – 17 for more details.

The ITI system has four serial lines available for external

equipment connection.

→ Please refer to page 6 for more details.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Keine Kommentare

Simrad ITI Bedienungsanleitung Seite 9